Key Features
- 200 HP catalogue versions are documented at 1000 rpm input.
- Separate 2.37:1 and 2.64:1 configurations retain their own torque ratings.
- Dimensional tables distinguish angle and length options by full code.
Product Applications
XH200 is documented for fertilizer spreader transmissions, with the website describing a PTO driven seed broadcaster or spreader installation. Selection should identify the intended implement drive and the required 237J or 264J arrangement. The gearbox data does not specify spreading width, application rate or compatibility with a particular material. Those complete machine requirements should accompany the gearbox interface drawings in an OEM enquiry.
Technical Specifications
|
Parameter |
Catalogue family specification |
|
Model family |
XH200 |
|
Application |
Fertilizer spreader transmission |
|
Input power |
200 HP |
|
Input speed |
1000 rpm |
|
237J ratio and torque |
2.37:1; 3450 Nm |
|
264J ratio and torque |
2.64:1; 3830 Nm |
|
Input spline |
1 3/4 inch Z6 |
|
Output spline |
DIN 5482 65 x 60 |
|
Dimensions |
Angle and L, A, B vary with the full catalogue code |
Product Design
The technical drawing shows the connected transmission assembly, input and output references and angular geometry. The associated table identifies configuration-dependent dimensions rather than one universal envelope. Use the complete code, spline standard and dimensional row together when reviewing the spreader layout.
Original Technical Sheet
PDF page 86 | Configuration codes and dimensions remain as published:

Original Technical Sheet
PDF page 87 | Configuration codes and dimensions remain as published:

Products Description
Q: What should an XH200 sample enquiry identify?
A: State whether the project requires the 2.37:1 or 2.64:1 catalogue arrangement and provide the spreader layout. Include the full existing marking because similar numeric suffixes do not establish an identical configuration.
Q: What does an OEM need to specify about the assembly angle?
A: Identify the required angle and dimensions L, A and B from the configuration table. Supply the connected shaft layout so the selected assembly can be reviewed against the implement geometry.
Q: Can an unlisted length or angle be requested?
A: Submit the proposed dimensional drawing, spline interfaces and operating duty as a customization enquiry. The catalogue lists several arrangements, but a new combination requires a separate engineering response.
Q: Which checks are appropriate for a spreader transmission order?
A: Compare the complete code, selected ratio, spline interfaces, assembly angle and listed lengths. Any project-specific load test or dimensional report should be defined against the approved configuration.
Q: How should support enquiries identify a supplied transmission?
A: Send the nameplate, photographs of the full assembly and the measured connection layout. Include input speed and selected ratio so technical support can distinguish the 237J and 264J configurations.
Enquiry Information
Include the complete model and configuration, machine application, selected ratio, input speed and mating component drawings with an enquiry. Sample supply, OEM identification, customization scope, inspection documents and service arrangements are addressed in the quotation or order agreement for the specified configuration.
Hot Tags: pto broadcast fertilizer gearbox, China, manufacturers, suppliers, factory, wholesale, quotation, bulk, made in China
